The thermostat would not help the network if it was learned in on battery power. Then I reset Z-Wave on the panel and started over, adding both locks, light controller and thermostat. So I re-added the thermostat (battery powered I don’t have a C wire) and put it in another strategic location. This maps the signal routes and is required in order to help resolve the mesh network issues. I found a plug-in light controller in a cabinet and added it (GE ZW 4101) to Z-Wave devices and put it halfway between the panel and lock.Ī repeating device is a good solution, but you would need to run a network rediscovery on the 2GIG panel after adding the device and moving everything back to its permanent location. If the CT100 was on a C-wire and acting as a repeater, it would likely throw off the network, so this is likely. First it was the lock on the other side of the house that appeared to be out of range. It may be best to update to a newer model of lock, but there are a few things from above to address: Then I removed the CT100 thermostat in favor of a Wi-Fi ‘stat. As the 909 is not officially supported, we could not guarantee it would work appropriately with current panel firmware. Officially the compatible versions of the Kwikset locks starts with the 910. Any suggestions?Īs an aside, can any of the Kwikset locks have their user codes managed from ADC/GC2 panel? It seems like the locks I have are early models and don’t support a master code and multiple user codes – just the two that are programmed at the lock itself. So, while I’ve really liked lock automation, it’s caused some real headaches, such as when the petsitter calls and can’t get it, or the alarm starts blaring after the door is unlocked by code. Still didn’t have a reliable lock connection. I found a plug-in light controller in a cabinet and added it (GE ZW 4101) to Z-Wave devices and put it halfway between the panel and lock. Then I removed the CT100 thermostat in favor of a Wi-Fi 'stat. For a time, everything seemed to work fine. The Z-Wave module was fine, so I got a replacement lock PCB on eBay. One of the locks was broken when we moved in (batteries inserted wrong leaked onto PCB goodbye electronics). I used to see something like “Kitchen unlocked by user slot 1” in the event log. ![]() The locks also don’t report un/lock events to ADC anymore. However, my rules to dis/arm the panel when un/locking the locks don’t work. Currently, both will report their status to the panel and can be un/locked from there or mobile/web. The locks have been a challenge to get/keep working right. This was all installed by the previous owners by Vivint and I switched it over to ADC/Surety a few months ago.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |